User-Bind (Layer 2 Ethernet Port View) - HP A5500 EI Command Reference Manual

Hide thumbs Also See for A5500 EI:
Table of Contents

Advertisement

Examples
# Configure dynamic IPv4 binding of packet source IP address and MAC address on Layer 2 Ethernet
port GigabitEthernet 1/0/1 to filter packets based on the dynamically generated DHCP snooping entries.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ip check source ip-address mac-address
# Configure dynamic IPv4 binding of packet source IP address and MAC address on VLAN-interface 100
to filter packets based on the dynamically generated DHCP relay entries.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ip check source ip-address mac-address
# Configure dynamic IPv6 binding of packet source IP address and MAC address on Layer 2 Ethernet
port GigabitEthernet 1/0/1 to filter packets based on the dynamically generated DHCPv6 snooping
entries or ND snooping entries.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ip check source ipv6 ip-address mac-address

user-bind (Layer 2 Ethernet port view)

Syntax
user-bind [ ipv6 ] { ip-address ip-address | ip-address ip-address mac-address mac-address | mac-
address mac-address } [ vlan vlan-id ]
undo user-bind [ ipv6 ] { ip-address ip-address | ip-address ip-address mac-address mac-address | mac-
address mac-address } [ vlan vlan-id ]
View
Layer 2 Ethernet port view
Default level
2: System level
Parameters
ipv6: Binds an IPv6 address. Without this keyword, an IPv4 address is bound.
ip-address ip-address: Specifies the IP address for the static binding. The IPv4 address can only be a
Class A, Class B, or Class C address and can be neither 127.x.x.x nor 0.0.0.0. The IPv6 address cannot
be all 0s, a multicast address, or a loopback address.
mac-address mac-address: Specifies the MAC address for the static binding in the format H-H-H. The
MAC address cannot be all 0s, all Fs (a broadcast address), or a multicast address.
vlan vlan-id: Specifies the VLAN for the static binding. vlan-id is the ID of the VLAN to be bound, in the
range 1 to 4094. The switch does not support the vlan vlan-id option.
Description
Use the user-bind command to configure a static binding.
Use the undo user-bind command to delete a static binding.
By default, no static binding exists on a port.
310

Advertisement

Table of Contents
loading

This manual is also suitable for:

A5500 si

Table of Contents