Table of Contents
Advertisement
No matter whether portal authentication is enabled or not, you can only add or remove a portal-free rule.
You cannot modify it.
For Layer 2 portal authentication, you can configure only portal-free rules that are from any source
address to any or a specified destination address. With such a portal-free rule configured, users can
access the specified address without portal authentication.
Related commands: display portal free-rule.
Examples
# Configure a portal-free rule, allowing all packets to bypass portal authentication.
<Sysname> system-view
[Sysname] portal free-rule 15 destination ip any
portal local-server
Syntax
portal local-server { http | https server-policy policy-name }
undo portal local-server { http | https }
View
System view
Default level
2: System level
Parameters
http: Specifies that the local portal server use HTTP to exchange authentication packets with clients.
https: Specifies that the local portal server use HTTPS to exchange authentication packets with clients.
server-policy policy-name: Specifies the SSL server policy to be associated with the HTTPS service. policy-
name indicates an SSL server policy name, a case-insensitive string of 1 to 16 characters.
Description
Use the portal local-server command to configure the protocol type to be supported by the local portal
server and load the default authentication page file.
Use the undo portal local-server command to cancel the configuration.
By default, the local portal server does not support any protocol type.
When executing this command, the local portal server will load the default authentication page file,
which is supposed to be saved in the root directory of the device. To ensure that the local portal server
uses the user-defined default authentication pages, edit and save them properly before executing this
command. Otherwise, the system default authentication pages will be used.
If you specify HTTP in this command, the redirection URL for HTTP packets is in the format of http://IP
address of the device/portal/logon.htm, and clients and the portal server exchange authentication
information through HTTP.
If you specify HTTPS in this command, the redirection URL for HTTP packets is in the format of https://IP
address of the device/portal/logon.htm, and clients and the portal server exchange authentication
information through HTTPS.
147
Advertisement
Table of Contents
