Table of Contents
Advertisement
Description
Use the accounting-on enable command to enable the accounting-on feature and specify the
retransmission interval and the maximum number of transmission attempts. After doing so, when the
device reboots, an accounting-on message will be sent to the RADIUS server to log out the online users of
the device.
Use the undo accounting-on enable command to disable the accounting-on feature.
By default, the accounting-on feature is disabled.
Parameters set with the accounting-on enable command take effect immediately.
NOTE:
When you execute the accounting-on enable command, if the accounting-on feature is already
enabled for another authentication scheme, the command takes effect immediately. Otherwise, you
must save the configuration by using the save command, so that the command takes effect after the
device reboots. For more information about the save command, see the
Reference.
Related commands: radius scheme.
Examples
# Enable the accounting-on feature for RADIUS authentication scheme rd, set the retransmission interval
to 5 seconds, and set the transmission attempts to 15.
<Sysname> system-view
[Sysname] radius scheme rd
[Sysname-radius-rd] accounting-on enable interval 5 send 15
attribute 25 car
Syntax
attribute 25 car
undo attribute 25 car
View
RADIUS scheme view
Default level
2: System level
Parameters
None
Description
Use the attribute 25 car command to specify to interpret the RADIUS class attribute (attribute 25) as CAR
parameters.
Use the undo attribute 25 car command to restore the default.
By default, RADIUS attribute 25 is not interpreted as CAR parameters.
Related commands: display radius scheme and display connection.
38
Fundamentals Command
Advertisement
Table of Contents
