Table of Contents
Advertisement
standard: Specifies the standard RADIUS server, which requires the RADIUS client end and RADIUS
server to interact according to the regulation and packet format of the standard RADIUS protocol (RFC
2865/2866 or newer).
Description
Use the server-type command to configure the RADIUS server type.
Use the undo server-type command to restore the default.
By default, the supported RADIUS server type is standard.
Related commands: radius scheme.
Examples
# Configure the RADIUS server type of RADIUS scheme radius1 as standard.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] server-type standard
state primary
Syntax
state primary { accounting | authentication } { active | block }
View
RADIUS scheme view
Default level
2: System level
Parameters
accounting: Sets the status of the primary RADIUS accounting server.
authentication: Sets the status of the primary RADIUS authentication/authorization server.
active: Specifies the active state, the normal operation state.
block: Specifies the blocked state, the out-of-service state.
Description
Use the state primary command to set the status of a primary RADIUS server.
By default, the primary RADIUS server specified for a RADIUS scheme is in the active state.
During an authentication or accounting process, the device first tries to communicate with the primary
server if the primary server is in the active state. If the primary server is unavailable, the device changes
the status of the primary server to blocked, starts a quiet timer for the server, and then tries to
communicate with a secondary server in the active state (a secondary RADIUS server configured earlier
has a higher priority). When the quiet timer of the primary server times out, the status of the server
changes to active automatically. If you set the status of the server to blocked before the quiet timer times
out, the status of the server cannot change back to active automatically unless you set the status to active
manually.
When the primary server and secondary servers are both in the blocked state, the device communicates
with the primary server.
Related commands: display radius scheme and state secondary.
65
Advertisement
Table of Contents
