Secondary Authentication (Hwtacacs Scheme View) - HP A5500 EI Command Reference Manual

The HWTACACS service port configured on the device and that of the HWTACACS server must be
consistent.
If you configure the command repeatedly, only the last configuration takes effect.
If the server to be specified resides on an MPLS VPN, you also need to specify that VPN by using the
vpn-instance vpn-instance-name keyword and argument combination to ensure normal communication
with the server. The VPN specified here takes precedence over the VPN specified for the RADIUS scheme.
You can remove an accounting server only when it is not used by any active TCP connection to send
accounting packets.
Related commands: display hwtacacs, hwtacacs scheme, and vpn-instance (HWTACACS scheme view).
Examples
# Specify the IP address and port number of the secondary accounting server for HWTACACS scheme
hwt1 as 10.163.155.12 with TCP port number 49.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary accounting 10.163.155.12 49

secondary authentication (HWTACACS scheme view)

Syntax
secondary authentication ip-address [ port-number | vpn-instance vpn-instance-name ] *
undo secondary authentication
View
HWTACACS scheme view
Default level
2: System level
Parameters
ip-address: IP address of the secondary HWTACACS authentication server, a valid unicast address in
dotted decimal notation. The default is 0.0.0.0.
port-number: Port number of the secondary HWTACACS authentication server. It ranges from 1 to 65535
and defaults to 49.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN that the secondary HWTACACS
authentication server belongs to, where vpn-instance-name is a case-sensitive string of 1 to 31 characters.
If the server is on the public network, do not specify this keyword and argument combination.
Description
Use the secondary authentication command to specify the secondary HWTACACS authentication server.
Use the undo secondary authentication command to remove the configuration.
By default, no secondary HWTACACS authentication server is specified.
The IP addresses of the primary and secondary authentication servers cannot be the same. Otherwise, the
configuration fails.
The HWTACACS service port configured on the device and that of the HWTACACS server must be
consistent.
84