Section Overview; Safety Messages; Hazardous Locations Certifications - Emerson Rosemount 2051 Reference Manual

Reference Manual
00809-0300-4101, Rev BB
Section 2
Section overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5
Hazardous locations certifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5
Configuration guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 6
Basic setup tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 7
Detailed setup tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 9
2.1

Section overview

This section contains information on commissioning the Rosemount
Transmitter with PROFIBUS
Class 2 Master.
2.2

Safety messages

Procedures and instructions in this section may require special precautions to ensure the
safety of the personnel performing the operations. Information that raises potential safety
issues is indicated by a warning symbol (
performing an operation preceded by this symbol.
Explosions could result in death or serious injury.
Installation of this transmitter in an explosive environment must be in accordance with the
appropriate local, national, and international standards, codes, and practices. Review the
approvals section of this Reference Manual for any restrictions associated with a safe
installation.
In an Explosion-Proof/Flameproof installation, do not remove the transmitter covers

when power is applied to the unit.
Process leaks may cause harm or result in death.
Install and tighten process connectors before applying pressure.

Electrical shock can result in death or serious injury.
Avoid contact with the leads and terminals. High voltage that may be present on leads

can cause electrical shock.
2.3

Hazardous locations certifications

Individual transmitters are clearly marked with a tag indicating the approvals they carry.
Transmitters must be installed in accordance with all applicable codes and standards to
maintain these certified ratings. Refer to
information on these approvals.
Configuration
Configuration
®
PA Protocol using either the Local Operator Interface (LOI) or
"Product Certifications" on page 131
). Refer to the following safety messages before
Configuration
November 2016
™
2051 Pressure
for
5