Check Of Internal Components - MCZ Polar Installation And Use Manual

On the rear of the stove there is a fuse holding compartment which is
located underneath the supply socket. With a screwdriver open the
cover of the fuse holding compartment, and replace the fuse if
necessary (3.15 AT delayed type).
Plug the unit back in and press the main switch.
If the problem persists or occurs again, contact your MCZ retailer.
5.3.

CHECK OF INTERNAL COMPONENTS

ATTENTION!
The check
components must be carried out only by qualified
personnel with technical knowledge of electricity and
combustion. If necessary, contact authorized MCZ
retailers.
We recommend that an annual maintenance service is carried out,
preferably under a programmed service contract. The essential part of
this service is a visual and functional check on the following
components:
• Reduction motor
• Smoke expulsion fan
• Smoke sensor
• Heat-exchanger fan
• Ignition sparkplug
• Resettable pellet thermostat
• Room temperature sensor
• Pressure switch
•
Motherboard / service card
• Fuses protecting panel - motherboard - services card
• Wiring
The following is a summary of the checks and/or maintenance tasks which are indispensable for the correct
operation of the stove.
Parts / interval
Burner
Ash drawer
Glass
Lower exchanger
Complete exchanger
Smoke duct
Ash drawer door gasket
Internal parts
Flue pipe
Circulation pump
Plate heat exchanger
Plumbing components
Electro-mechanical components
Maintenance and cleaning
PELLET STOVES
INSTALLATION AND USE MANUAL
Figure 9
of the internal
Every
day
●
Figure 9 – Switch with fuse box
electromechanical
Every Every
2-3 days 30 days
●
●
●
●
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
Chapter 5
58
page
Fuse
box
Every Every
60-90 days 1 year
●
●
●
●
●
●
●
●