Clock (Code On Display Ut 02 And Ut 03) - MCZ Polar Installation And Use Manual

Press twice more on button
messages "DAY 6 → DAY 5".
The display (8) will now show the message "DAY 5" alternating with
"UT 01".
the code
The same procedure can be implemented using the button
difference is that the menu scrolls in the opposite direction as shown:
"OFF →DAY 1→DAY 2→DAY 3→DAY 4→DAY 5"
To memorize the setting, press the button
SUMMARY:
To ACTIVATE the PROGRAMMED mode (indicator light 9 on) press in
sequence the buttons
the buttons or
memorize, press the button
ATTENTION!
Any day memorized except for the message "OFF"
activates PROGRAMMED mode.
To DE-ACTIVATE PROGRAMMED mode (indicator light 9 off), press in
sequence buttons and
the buttons or until the message "OFF" is shown; confirm by
pressing the button .
Only the memorized message "OFF" de-activates the
PROGRAMMED mode.

Clock (code on display UT 02 and UT 03)

4.10.4.2.
See paragraph 4.5.1. on time setting to find out how to set the current
time.
The following are the main points.
• Setting of HOURS (code on display UT 02)
Press the buttons
parameter "UT 01". Use the button
"UT02" which corresponds to the time on the clock expressed in
HOURS.
The display (8) will alternately show the code "UT 02" and the
indication of the internal time of the stove present at that moment.
Use the button (increase) or
To memorize, press the button
display, "UT 03", to set the minutes.
• Setting of MINUTES (code on display UT 03)
The display (8) will alternately show the code "UT 03" and the
current minutes on the clock.
Use the button (increase) or
To memorize, press the button
of "UT 04".
Operation
INSTALLATION AND USE MANUAL
and you will see in sequence the
and to show the code
to increase or decrease the start day. To
.
to display the code "UT 01". Then press
and to access the setting menu and
to access the parameter
(decrease) to set the hours.
, which will take you to the next
(decrease) to set the minutes.
. This will take you to the display
PELLET STOVES
. The only
.
"UT 01"
. Then press
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
2
Ut 01
!
SET
63°C
1 6
Buttons for menu access.
2
Ut 01
!
SET
day5
1 6
Selection of current day and
programmed mode.
Chapter 4
44
page
3
5
4
TURBO
3
5
4
TURBO
activation of