Settings To Carry Out Before First Lighting; Setting Current Time; Selection Of Recipe; Operations For Identification Of The Recipe - MCZ Polar Installation And Use Manual

4.5. SETTINGS TO CARRY OUT BEFORE FIRST
LIGHTING
Set the main switch on the rear of the stove to position (I).
The display (8) of the control panel will show the message OFF and the
CURRENT TIME.
If the time shown is not correct, it can be reset by the procedure
described below.
You should keep in mind that the current time is only
needed when you carry out weekly programming
using the TIMER (see corresponding chapter). If the
time is not set correctly, this does not in any way
affect stove operation.
4.5.1.

SETTING CURRENT TIME

In rapid sequence, press the buttons
UT01
parameter . If you again press the button
UT02, which shows the hours. Use the buttons
increase the hours.
To confirm the hour selected and move on to selection of the minute,
press key . (you will see the item
Use keys or to decrease/increase the minute (steps of 1 minute).
To confirm the set time and exit, press
4.6.

SELECTION OF RECIPE

This is an exclusive MCZ evaluation criteria. It lets the user
identify the type of pellet to be used and as a result to provide
the stove with the most suitable settings. This prevent fuel
waste, ensures expected heating capability and protects the
condition of the product.
RECIPE SELECTION IS TO BE MADE
AT INITIAL INSTALLATION AND ANY
TIME THE
CHANGED.
(E.g. when you change supplier or when you notice differences in
colour or size of the pellets)
4.6.1. OPERATIONS FOR IDENTIFICATION OF THE
RECIPE:
• Identification of type of fuel
Operation
PELLET STOVES
INSTALLATION AND USE MANUAL
and to access technical
, you will access item
or
UT03
)
TYPE OF PELLET
to decrease or
Sequence to access setting of hours and
minutes.
IS
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
Chapter 4
page
SWITCH
2
Ut 01
!
5
SET
day 1
1 6
TURBO
2
Ut 02
!
5
SET
1 6:
1 6
TURBO
2
Ut 03
!
5
SET
: 1 0
1 6
TURBO
35
3
4
3
4
3
4