Programme 1 - MCZ Polar Installation And Use Manual

The code "UT 04" is not part of PROGRAMMED mode.
It is to be used only by the installer or a qualified
technician from MCZ by means of an access key.
Press button 3 again to proceed and to display the
code "UT 05".
Programme
4.10.4.3.
The POLAR, NOVA and ATHOS stoves can run up to 4 operating
programmes distributed over the course of the day or for the entire
week.
Each programme features three basic steps:
• The time the stove comes on (it must be between 00:00
and 23:40)
• The time the stove shuts down (it must be greater than
the start time, up to a maximum 23:50)
• The days in which the lighting or extinguishing of the
stove must be ACTIVATED or DEACTIVATED
Please look at PROGRAMME 1 (summarized in the following table). It
is the first of four programmes in the programming sequence.
Symbol on display
(8)
Data to be inserted Schedule
Lighting the
PROGRAMME 1: setting of stove lighting time.
UT 05
This is step . The display (8) of the stove panel alternates
UT 05
between the message
minutes. Use the keys
of lighting of the stove for this programme. Each time the key is
pressed, the time increases or decreases by 10 minutes. If you hold the
key down, the increase or decrease is gradually faster. This lets you
make large changes rapidly. Once you have set the time you want,
memorize it by pressing the key
UT 06
the next step, .
PROGRAMME 1: setting of stove shutdown time.
UT 06
This is step . The display (8) of the stove panel alternates
UT 06
between the message
minutes. Use the keys
of shutdown of the stove for this programme. Each time the key is
pressed, the time increases or decreases by 10 minutes. If you hold the
key down, the increase or decrease is gradually faster. This lets you
make large changes rapidly. Once you have set the time you want,
memorize it by pressing the key
UT 07
the next step, .
PROGRAMME 1: setting of activated or de-activated days.
UT 07
This is step . The display (8) of the stove will alternate between
UT 07
the code and one of the following: ON 1, OFF 1, ON 2, OFF 2,
Operation
INSTALLATION AND USE MANUAL

PROGRAMME 1

UT 05 UT 06
Schedule
Shutdown
stove
and a time value expressed in hours and
(increase) or (decrease) to set the time
. This will take you automatically to
and a time value expressed in hours and
(increase) or (decrease) to set the time
. This will take you automatically to
PELLET STOVES
UT 07
Days activated or
deactivated
On/Off 1,2,3,4,5,6,7
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
Chapter 4
45
page