Interface Grouping - Tenda V300 User Manual

4.17

Interface Grouping

If you create multiple WAN services (PPPoE and other WAN service types), and want a LAN or WLAN to use a
WAN service exclusively, you can use this function to create mapping groups with appropriate LAN and WAN
interfaces. Each group performs as an independent network.
Choose Advanced > Advanced Setup > Interface Grouping to enter the configuration page.
To create a mapping group, perform the following procedure:
Assume that:

The modem router accesses the internet through port 1 using an Ethernet cable.

You create two WAN services: the WAN service type for one is IP over Ethernet and Obtain an IP address
automatically, and the other is bridging.

You want all wireless devices to use IP over Ethernet WAN service, and all wired device use bridging WAN
service.
Step 1 Click Add.
Step 2 Specify a group name.
Step 3 Select a WAN service you create, ipoe_LAN1/eth0.1 here.
Step 4 Select an interface in Available LAN Interfaces list and click
Interfaces list. Move all wireless interfaces to Grouped ALN Interfaces list here.
86
button to move it to Grouped ALN