Ethernet Cable Connection - Tenda V300 User Manual

Step 4 Click OK on the bottom of the page to apply the settings.
--End
ADSL
If the link type your internet service provider provided to you is ADSL, follow the procedures below:
Step 1 Log in to the web UI and enter the Home page.
Step 2 Link Type: Select ADSL.
Step 3 Connection Type: Select a connection type according to the instructions in the table below, and
complete the related internet parameters.
Connection Type
PPPoE (PPP over Ethernet)
PPPoA (PPP over ATM)
Dynamic IP
IPoE (IP over
Ethernet)
Static IP
IPoA (IP over
Static IP
ATM)
Bridge
Step 4 Country/Region: Select your country or region.
Step 5 ISP: Select your internet service provider.
Step 6 Enter the related internet parameters provided by your ISP.
Step 7 Click OK on the bottom of the page to apply the settings.
--End
If your country/region and ISP are not covered in the drop-down list, select Other, and enter the VPI
and VCI manually. If you do not know the VPI and VCI, contact your ISP for help.
2.4.2

Ethernet Cable Connection

If you connect the modem router to the internet via an Ethernet cable, refer to the configuration in this part to
complete your internet settings. In this case, this device only serves as a wireless router.
10
internet parameters directly on your computer for internet
access.
Description
If your internet service provider (ISP) provides a user name
and password to you for internet access, your connection
type may be PPPoE or PPPoA, contact your ISP for details.
Select thus type if your ISP does not provide any parameters
to you for internet access.
If your internet service provider provides a static IP address
and other related information to you for internet access, your
connection type may be IPoE or IPoA, contact your ISP for
details.
Select thus type when this device only serves as a modem,
and you want to set up a dial-up connection or enter other
internet parameters directly on your computer for internet
access.