Tenda V300 User Manual page 119

(4) Log in to the modem router using the new LAN IP address 192.168.1.10. (If you cannot
log in to the web UI of the modem router with the new LAN IP address, disable the adapter
of your computer, and then enable it again to obtain an IP address again.)
(5)
Choose Advanced > Wireless > Basic to enter the configuration page.
(6)
Set the Channel to 6.
(7)
Click Apply/Save on the bottom of this page.
(8)
Choose Advanced > Wireless > Security to enter the configuration page.
(9)
Set the Network Authentication, WPA/WAPI Passphrase, and WPA/WAPI Encryption
to Mixed WPA2/WPA-PSK, 12345678, and AES respectively.
(10)
Click Apply/Save on the bottom of this page.
Configure the access point function.
(11)
Choose Advanced > Wireless > Wireless Bridge to enter the configuration page.
(12)
Set the AP Mode to Access Point.
(13) Set the Bridge Restrict to Enabled (Scan).
(14)
Select the SSID (wireless network name) of the upstream router which is
Tenda_XXXXXX in this example.
(15) Click Apply/Save.
111