Routing; Defauly Gateway; Static Route - Tenda V300 User Manual


Mark 802.1p priority: Tag an 802.1p priority mark for the data stream.

Set Rate Limit: Specify the maximum transmission speed of the queue.
Step 7 Click Apply/Save.
--End
4.12

Routing

4.12.1

Defauly Gateway

Default gateway interface list can have multiple WAN interfaces served as system default gateways but only one
will be used according to the priority with the first being the highest and the last one the lowest priority if the
WAN interface is connected. Priority order can be changed by removing all and adding them back in again.
Choose Advanced > Advanced Setup > Routing > Defauly Gateway to enter the configuration page.
Selected Default Gateway Interfaces: It specifies the current default IPv4 gateway interface in effect. If there are
many interfaces in the list, the first one always takes effect.
Select a WAN interface and click the
Available Routed WAN Interfaces: It Specifies the current alternative default IPv4 gateway interface. Select a
WAN interface and click the
IPV6 Selected WAN Interface: Select the current IPv6 gateway interface in effect from the drop-down list.
4.12.2

Static Route

Static Route is performed to select the best route for delivering data from a source address to a destination
address. A static route is a manually configured route, which is simple, efficient, and reliable. Appropriate static
routes help reduce the number of route selection problems and reduce route selection load, increasing the
packet forwarding speed.
70
button to move it to the Available Routed WAN Interfaces box.
button to add it to the Selected Default Gateway Interfaces box.