Tenda V300 User Manual page 38

Step 2 Select the interface you create in Layer2 Interface, interface atm0/(0_1_35) here.
Step 3 Click Next.
Step 4 Select a WAN service type according to the instructions in the table below. Here take PPPoE as an
example.
Connection Type
PPP over Ethernet (PPPoE)
Dynamic IP
IP over Ethernet
Static IP
Bridging
Step 5 Select PPP over Ethernet.
Step 6 Network Protocol Selection: Select your network protocol type. The modem router provides three
types of network protocol: IPv4 Only, IPv4&IPv6, and IPv6 Only. Here take IPv4 Only as an example.
Step 7 Click Next.
30
Description
Select thus type if your internet service provider (ISP) provides a user
name and password to you for internet access.
Select thus type if your ISP does not provide any parameters to you for
internet access.
Select thus type if your ISP provides a static IP address and other
related information to you for internet access.
Select thus type when this device only serves as a modem, and you
want to set up a dial-up connection or enter other internet parameters
directly on your computer for internet access.