Tenda V300 User Manual page 79

Choose Advanced > Advanced Setup > Routing > Static Route to enter the configuration page.
To add a static route, perform the following procedure:
Step 1 Click Add.
Step 2 IP Version: Specify an IP protocol version for the static route: IPv4 or IPv6.
Step 3 Destination IP address/prefix length: Set a destination IP address.

Destination Host is a specified host whose prefix length is 32. For example, the host 1.2.3.4 indicates
"1.2.3.4/32".

Destination Network is a specified network whose IP address is the network address of the destination host.
For example, the network 2.2.3.3/255.255.0.0 indicates "2.2.0.0/16" which represents all hosts whose IP
address start with "2.2".
Step 4 Interface: Specify an outgoing interface for the data.
Step 5 Gateway IP Address: set the gateway IP address to the IP address of the next-hop router.
Step 6 (Optional) Metric: Specify a metric value for the static route. Lower number leads to higher priority.
--End

Destination IP address cannot be in the same IP network segment as that of WAN or LAN of the
modem router.
71