To Set Up The Ethernet Interface - Tenda V300 User Manual

Static IP
IPoA (IP over
Static IP
ATM)
Bridge
And then refer to To Set up WAN Service for ATM Interface
--End
If you are unsure about the VPI/VCI parameters, refer to
VPI/VCI information is not covered there, ask your ISP to provide it.
4.1.3

To Set up the Ethernet Interface

Log in to the web UI, choose Advanced > Advanced Setup > Layer2 Interface > Ethernet to enter the following
page.
Step 1 Click Add.
Step 2 Click Apply/Save.
24
If your internet service provider provides a static IP address and other
related information to you for internet access, your connection type
may be IPoE or IPoA, contact your ISP for details.
Select thus type when this device only serves as a modem, and you
want to set up a dial-up connection or enter other internet parameters
directly on your computer for internet access.
to configure the WAN service for internet access.
Appendix 8.4 VPI/VCI List. If the ISP and the