To Set Up The Atm Interface - Tenda V300 User Manual

And then refer to To Set up WAN Service for PTM Interface
--End
4.1.2

To Set up the ATM Interface

Log in to the web UI, choose Advanced > Advanced Setup > Layer2 Interface > ATM to enter the following page.
Step 1 Click Add.
Step 2 Enter the VPI and VCI values.
Step 3 Select a DSL Link Type according to the instructions in the table below, and leave other options
unchanged. EoA (EoA is for PPPoE, IPoE, and Bridge.), PPPoA or IPoA.
Step 4 Click Apply/Save on the bottom of the page.
Connection Type
PPPoE (PPP over Ethernet)
PPPoA (PPP over ATM)
IPoE (IP over
Dynamic IP
Ethernet)
23
to configure the WAN service for internet access.
Description
If your internet service provider (ISP) provides a user name and
password to you for internet access, your connection type may be
PPPoE or PPPoA, contact your ISP for details.
Select thus type if your ISP does not provide any parameters to you for
internet access.