Camera Presets In Single Camera Mode - Polycom RealPresence Group User Manual

Camera Presets in Single Camera Mode

In Single Camera mode, camera presets are stored camera positions that you can create before or during
a call. Presets enable you to quickly point a camera at pre-defined locations in a room and select a video
source, such as a document camera or an auxiliary camera. Presets remain in effect until you change
them.
The system uses preset 0 as the default camera position for all preset camera positions. This default
camera position is zoomed out, panned straight ahead with horizontal tilt.
If your system camera supports pan, tilt, and zoom movement, you can create up to 10 preset camera
positions for the near-end camera. Each preset stores the following information:
▪ Camera number
▪ Camera zoom level
▪ Direction the camera points
If far-end camera control is allowed, you can create 10 presets for the far-end camera as well. These
presets are saved only for the duration of the call. You can also use presets that were created at the far
end to control the far-end camera, if enabled by the administrator.
Keep the following camera control information in mind when using Self View:
▪ When in a call, selecting near camera control pans and zooms the local camera without changing
the layout.
▪ When out of a call, selecting camera control changes the Self View to full screen.
▪ Incoming calls override the full-screen Self View layout.
View Stored Presets
When you store a preset, a snapshot of the area where the camera is pointing is saved. You can view
snapshots of previously stored presets at any time.
Procedure
1. Tap to open the Quick Access menu.
2. Tap Camera > Presets.
Select a Stored Preset
Using previously stored presets, you can quickly move the position of the camera.
Procedure
1. Tap to open the Quick Access menu.
2. Tap Camera > Presets and select a preset.
Store a Camera Preset
Camera presets are stored on the system until you replace the preset with a new snapshot.
Procedure
1. Tap Camera > Camera Control, and select the desired camera.
2. Position the camera to the desired area for the new preset.
3. Tap to open the Quick Access menu then tap Presets.
Polycom, Inc.
Using the Touch User Interface
62