Polycom RealPresence Group User Manual page 21

Switch Between Calls in a Conference Call
When you have a call on hold, you can switch between the held and active calls.
Procedure
1. Use your remote control to press
2. Choose the call you want to make active.
Resume a Held Call in a Conference Call
When there is a call on hold, you can resume the held call.
Procedure
1. Press .
2. Select Resume Call.
Hang Up an Individual Call in a Conference Call
During a conference call, you can hang up an individual call within the conference call.
Procedure
1. Using your remote control, press
2. Navigate to the call you want to end.
3. Select Hang Up.
Hang Up a Held Call and Accept a Call
Depending on how your system is set up, you can end the call that was on hold the longest and add an
incoming call to the conference.
Procedure
» Select Hang Up + Accept.
The oldest held call is ended and the incoming call is added to the conference.
Hang Up All Calls
When you are in a conference call, you can hang up one call at a time or hang up all calls at once.
Procedure
1. Press .
2. Select Leave Conference.
Passwords for Conference Calls
Depending on how a conference call is set up, you might be required to enter a meeting password to join
the call. You can also require far-end systems to enter a meeting password to prevent unauthorized
participants from joining conference calls hosted by your system.
Keep the following points in mind regarding meeting passwords:
▪ Audio-only endpoints are unable to participate in password-protected calls.
Polycom, Inc.
Using a Polycom RealPresence Group Series Remote Control
.
.
19