Ricoh MD-P2 Field Service Manual page 256

3. Appendix: SP Mode Tables
001 By-pass 0.0846mm
002 Tray1 0.0846mm
003 Tray2 0.0846mm
004 Duplex 0.0846mm
[Paper Buckle] Paper Buckle
1003
3
(Tray or By-pass, Paper Type, Process Speed)
002 Tray1 0.1mm
006 Tray2 0.1mm
014 By-pass 0.3mm
018 Duplex 0.1mm
[Lead Edge Reg.] Leading Edge Registration
1100 (Tray or By-pass, Paper Type, Process Speed)
Process Speed: LowSpd: Low Speed, HlfSpd: Half speed, NorSpd: Normal speed
These SPs can be adjusted by UP mode. The setting range of SP1100 is different from the
setting range of SP1001.
002 T1:NorSpd 0.3mm
003 T1:HlfSpd 0.3mm
006 T2:NorSpd 0.3mm
007 T2:HlfSpd 0.3mm
014 ByPas:NorSpd 0.3mm
015 ByPas:HlfSpd 0.3mm
018 Dup:NorSpd 0.3mm
021 Dup:HlfSpd 0.3mm
063 T1:LowSpd 0.3mm
065 ByPas:LowSpd 0.3mm
066 Dup:LowSpd 0.3mm
24
*EGB
Adjusts the side-to-side registration for each
*EGB
mode. This SP changes the laser main scan start
position.
*EGB
[-63 to 63 / 0 / 0.0846 mm /step]
*EGB
*EGB
Adjusts the amount of paper buckle at the
*EGB
registration roller for each mode. This SP
changes the paper feed timing.
*EGB
[-10.0 to 10.0 / 0.0 / 0.1 mm/step]
*EGB
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]
*EGB [0 to 9.0 / 0 / 0.3 mm/step]