Ricoh MD-P2 Field Service Manual page 143

5857 016 Make HDD Debug File
5857 017 Make SD Debug File
5858 [Debug Log Save: SC]
5858 001 Engine SC
5858 002 Controller SC
5858 003 Any SC
5858 004 Jam
5859 [Debug Log Save Key]
*CTL Makes a log file on the HDD to save debug logs.
To save debug logs, the controller makes a log
file first, then writes data in the file. This procedure
can use much time. The user can switch off the
main power switch before the log is written in the
*CTL
file. To prevent this possible problem, you can
prepare a log file in advance. If you do this, the
controller uses less time to save logs because the
log file is prepared.
Collects debug logs when an engine-related SC
code occurs.
*CTL
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
Collects debug logs when a controller-related SC
code occurs.
*CTL
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
Sets the SC code whose logs are collected.
*CTL
[00000 to 65535 / 0 / 1/step]
Collects debug logs when a paper jam occurs.
*CTL [0 or 1 / 0 / 1/step]
0: OFF, 1: ON
Main SP Tables: 1
5
141