Ricoh MD-P2 Field Service Manual page 210

6. Troubleshooting
Power Loss During Data Conversion
9 Data conversion stops before NVRAM/HDD data is converted.
• Format HDD with SP5832-1.
Data Read Command Error
More than two illegal DMAC communications are returned.
10
• HDD defective
• Format HDD with SP5832-1.
• Replace HDD.
860
HDD startup error at power on
B
HDD is connected but a driver error is detected.
6
-or-
The driver does not respond with the status of the HDD within 30 s.
• HDD is not initialized.
• Level data corrupted
• HDD is defective.
861
HDD re-try failure
D
At power on the HDD is detected. Power supply to the HDD is interrupted after the system
has entered the energy save mode, but after the HDD has been awakened from the
energy save mode it does not return to the ready status within 30 sec.
• Harness between HDD and controller board disconnected, defective
• HDD power connector disconnected
• HDD defective
• Controller board defective
863
HDD data read failure
D
208