Toshiba Q9 Installation And Operation Manual page 98

F212
RR Reference 2
Program  Frequency Settings
This parameter is used to set the gain and bias of the RR input terminal when the
RR terminal is used as the control input while operating in the Speed Control
mode or the Torque Control mode.
This parameter sets the RR input level that is associated with
when operating in the Speed control mode or is associated with the
Reference 2 when operating in the Torque Control mode.
This value is entered as 0% to 100% of the RR input signal range.
See RR Reference 1 for more information on this setting when used for Speed
control.
See RR Torque Reference 1 (F214) for more information on this setting when
used for Torque Control.
RR Frequency 2
Program  Frequency Settings
This parameter is used to set the gain and bias of the RR input terminal when the
RR terminal is used as the control input while operating in the Speed Control
mode.
This parameter sets RR Frequency 2
the setting of RR Reference 2
See RR Reference 1 (F210) for more information on this setting.
88
and is the frequency that is associated with
when operating in the Speed Control mode.
Direct Access Number — F212
Parameter Type — Numerical
Factory Default — 100
Changeable During Run — Yes
Minimum — 0
Maximum — 100
RR Frequency 2
RR Torque
Units — %
Direct Access Number — F213
Parameter Type — Numerical
Factory Default — 60.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
Q9 ASD Installation and Operation Manual
F213