Toshiba Q9 Installation And Operation Manual page 78

F040
Automatic Function Selection
No Path — Direct Access Only
This parameter setting is used to configure multiple parameters with the setting of
only one parameter. From the selection below multiple parameters may be set as
indicated in the table.
Once set, the selected configuration is placed in effect and remains in effect until
this parameter is changed or the individual settings are changed.
Set this parameter to Disable to set these parameters individually.
Note: After performing the desired selection the EOI display returns to
Disabled though the selected function has been carried out
(i.e.
, Without this, if selection 1 is performed,
would retain the RR terminal setting regardless of attempts to
change the settings individually).
Settings:
0 — Disabled
1 — RR
2 — V/I
3 — RR or VI/II (V/I) Switched via Terminal Board
4 — Keypad = Frequency/Terminal Board = Command
5 — Keypad = Frequency and Command
Related Default
0-Disabled 1-RR 2-V/I
Parameters Settings
CMOD Terminal
F003 Board
FMOD1
RR N/C
F004
S3 Terminal Preset
F117 Speed 3
Freq.
Terminal
Priority N/C
Board
F200
V/I Setup
0.0%
F201
FMOD2
V/I N/C
F207
N/C = No Change — the setting remains as it was before setting parameter F040.
68
F004
User Settings
3-RR or 4-Keypad/
V/I via
TB
N/C
RR N/C RR
Freq.
N/C Ref.
Priority
Terminal Board
N/C 20.0%
RR V/I
Direct Access Number — F040
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
and F207
5-Keypad
Freq.
Freq/CMD
CMD/TB
Terminal
Keypad
Board
Keypad
N/C
N/C
Keypad
Q9 ASD Installation and Operation Manual
F040