Toshiba Q9 Installation And Operation Manual page 180

F912
Input Function Target 1
Program  My Function Unit 3
This parameter plays a role in the setup of the My Function feature by selecting
the functionality of the programmable Input Function Target 1 terminal.
This setting assigns the function of the programmable Input Function Target 1
terminal to any of the user-selectable functions listed in
7 on pg. 190, or Table 8 on pg.
See F977 for more information on this parameter.
Input Function Command 1
Program  My Function Unit 3
This parameter is used to assign a user-selected logical operator to two user-
selected Input Function Target variables, enable a counter/timer function, or
perform a hold/reset function.
Table 9 on pg. 194 lists the available selections. Their use and selection
requirements are described in an example at F977.
Input Function Target 2
Program  My Function Unit 3
This parameter plays a role in the setup of the My Function feature by selecting
the functionality of the programmable Input Function Target 2 terminal.
This setting assigns the function of the programmable Input Function Target 2
terminal to any of the user-selectable functions listed in
7 on pg. 190, or Table 8 on pg.
See F977 for more information on this parameter.
Input Function Command 2
Program  My Function Unit 3
This parameter is used to assign a user-selected logical operator to two user-
selected Input Function Target variables, enable a counter/timer function, or
perform a hold/reset function.
Table 9 on pg. 194 lists the available selections. Their use and selection
requirements are described in an example at F977.
Input Function Target 3
Program  My Function Unit 3
This parameter plays a role in the setup of the My Function feature by selecting
the functionality of the programmable Input Function Target 3 terminal.
This setting assigns the function of the programmable Input Function Target 3
terminal to any of the user-selectable functions listed in
7 on pg. 190, or Table 8 on pg.
See F977 for more information on this parameter.
170
Table 5 on pg.
192.
Table 5 on pg.
192.
Table 5 on pg.
192.
Direct Access Number — F912
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
188, Table
Direct Access Number — F913
Parameter Type — Selection List
Factory Default — 0 (NOP)
Direct Access Number — F914
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
188, Table
Direct Access Number — F915
Parameter Type — Selection List
Factory Default — 0 (NOP)
Direct Access Number — F916
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
188, Table
Q9 ASD Installation and Operation Manual
F916