System Operation; Operation (Local); Default Setting Changes - Toshiba Q9 Installation And Operation Manual

System Operation

Operation (Local)

To run the motor perform the following steps:
1. Press the Mode key until the Frequency Command screen is displayed.
2. Press the Local/Remote key to enter the Local
mode (Local LED is illuminated).
3. Use the Rotary Encoder to set the desired
running speed.
Note: Ensure that there are no personnel around
or near the motor or the motor-driven
equipment.
4. Press the Run key (Green Run LED illuminates Red) and the motor runs at the Frequency
Command value set at step 3.
Note: The speed of the motor may be changed while the motor is running by using the
Rotary Encoder to change the Frequency Command value.
5. Press the Stop-Reset key to stop the motor.

Default Setting Changes

To change a parameter setting from the keypad, go to the Program menu by pressing the Mode key
until Program is displayed.
From the Program menu turn the Rotary Encoder until the desired parameter group is displayed. Press
the Rotary Encoder to access the sub-menu items — repeat as required until reaching the parameter to
be changed.
Once a parameter setting is displayed, press the Rotary Encoder to enter the Edit mode (parameter title
flashes). Turn the Rotary Encoder to change the parameter setting.
While still in the Edit mode, press ESC or the Mode key to exit the menu without saving the change, or
press the Rotary Encoder to accept and save the changed setting.
Note: Some parameters use the unsaved changed value until the ASD is Reset or powered
off (e.g., Frequency Command, Accel/Decel, etc.).
Turn the Rotary Encoder to repeatedly loop through the complete listing of sub-menu items for a given
Program Menu group.
For a complete listing of the Program menu items see the section titled
Navigation on pg.
From any menu, press the Mode key to return to the root menu. Repeated Mode key entries loop the
system through the root menus as shown in
Q9 ASD Installation and Operation Manual
41. The menu items are mapped for convenience.
Frequency Command Screen.
Figure 25 on pg. 37.
Program Mode Menu
57