Equipment Inspection; Handling And Storage; Disposal - Toshiba Q9 Installation And Operation Manual

Equipment Inspection

• Upon receipt of the equipment inspect the packaging and equipment for shipping damage.
• Carefully unpack the equipment and check for damaged parts, missing parts, or concealed damage
that may have occurred during shipping. If any discrepancies are discovered, it should be noted
with the carrier prior to accepting the shipment, if possible. File a claim with the carrier if necessary
and immediately notify your Toshiba Sales Representative.
• DO NOT install the ASD if it is damaged or if it is missing any component(s).
• Ensure that the rated capacity and the model number specified on the nameplate conform to the
order specifications.
• Modification of this equipment is dangerous and is to be performed by factory trained personnel.
When modifications are required contact your Toshiba Sales Representative.
• Inspections may be required after moving equipment.
• Contact your Toshiba Sales Representative to report discrepancies or for assistance if required.

Handling and Storage

• Use proper lifting techniques when moving the ASD; including properly sizing up the load, getting
assistance, and using a forklift if required.
• Store in a well-ventilated location and preferably in the original carton if the equipment will not be
used upon receipt.
• Store in a cool, clean, and dry location. Avoid storage locations with extreme temperatures, rapid
temperature changes, high humidity, moisture, dust, corrosive gases, or metal particles.
• The storage temperature range of the Q9 ASD is -13° to 149° F (-25° to 65° C).
• DO NOT store the unit in places that are exposed to outside weather conditions (i.e., wind, rain,
snow, etc.).
• Store in an upright position.

Disposal

Never dispose of electrical components via incineration. Contact your state environmental agency for
details on disposal of electrical components and packaging in your area.
Q9 ASD Installation and Operation Manual 3