Toshiba Q9 Installation And Operation Manual page 120

F303
Number of Retries
Program  Protection
After a trip has occurred, this parameter sets the number of times that an
automatic system restart is attempted for a qualified trip.
The trip conditions listed below will not initiate the automatic Retry/Restart
function:
• Input Phase Loss (Input Phase Failure)
• Output Phase Loss (Output Phase Failure)
• Output Current Protection Fault
• Output Current Detector error
• Load Side Over-Current At Start
• Earth Fault (Ground Fault)
• Over-Current During Acceleration
• Arm Over-Current at start-up
• Low-Current
• Voltage Drop In Main Circuit
• EEPROM Data Fault (EEPROM Fault)
• Flash Memory/Gate Array/RAM-ROM Fault
• CPU Fault
• Emergency Off (EMG)
• Communication Error
• Option Fault
• Sink/Source Setting Error
• Overspeed Error
• Over-Torque
• Key Error
• External Thermal Error
• Externally-Controlled Interrupt
See the section titled System Setup Requirements on pg. 8
on this setting.
110
Direct Access Number — F303
Parameter Type — Numerical
Factory Default — 00
Changeable During Run — Yes
Minimum — 00
Maximum — 10
for more information
Q9 ASD Installation and Operation Manual
F303