Toshiba Q9 Installation And Operation Manual page 91

F193
V/f 5-Point Setting Voltage 2
No Path — Direct Access Only
The V/f 5-Point Setting Voltage 2 establishes the output voltage level that is to
be associated with the frequency setting of
2).
The F701 parameter setting will determine if the selection for this parameter
appears in the form of a Voltage (V) or as a Percentage (%) of the ASD rating.
The default setting is %.
See F190 and F191 for additional information on this setting.
V/f 5-Point Setting Frequency 3
No Path — Direct Access Only
The V/f 5-Point Setting Frequency 3 sets the frequency to be associated with the
voltage setting of parameter
See F190 and F191 for additional information on this setting.
V/f 5-Point Setting Voltage 3
No Path — Direct Access Only
The V/f 5-Point Setting Voltage 3 establishes the output voltage level that is to
be associated with the frequency setting of
3).
The F701 parameter setting will determine if the selection for this parameter
appears in the form of a Voltage (V) or as a Percentage (%) of the ASD rating.
The default setting is %.
See F190 and F191 for additional information on this setting.
V/f 5-Point Setting Frequency 4
No Path — Direct Access Only
The V/f 5-Point Setting Frequency 4 sets the frequency to be associated with the
voltage setting of parameter
See F190 and F191 for additional information on this setting.
V/f 5-Point Setting Voltage 4
No Path — Direct Access Only
The V/f 5-Point Setting Voltage 4 establishes the output voltage level that is to
be associated with the frequency setting of
4).
The F701 parameter setting will determine if the selection for this parameter
appears in the form of a Voltage (V) or as a Percentage (%) of the ASD rating.
The default setting is %.
See F190 and F191 for additional information on this setting.
Q9 ASD Installation and Operation Manual
F192 (V/f 5-Point Setting Frequency
F195 (V/f 5-Point Setting Voltage 3).
F194 (V/f 5-Point Setting Frequency
F197 (V/f 5-Point Setting Voltage 4).
F196 (V/f 5-Point Setting Frequency
Direct Access Number — F193
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — No
Minimum — 0.0
Maximum — 100.0
Units — V or % (F701)
Direct Access Number — F194
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — No
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F195
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — No
Minimum — 0.0
Maximum — 100.0
Units — V or % (F701)
Direct Access Number — F196
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — No
Minimum — 0.00
Maximum — Max. Freq. (F011)
Units — Hz
Direct Access Number — F197
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — No
Minimum — 0.0
Maximum — 100.0
Units — V or % (F701)
F197
81