Omron E5AC-T User Manual page 410

Parameters Characters
hys
Hysteresis (Heating)
chys
Hysteresis (Cooling)
mv-r
MV at Reset
mv-e
MV at PV Error
ol-h
MV Upper Limit
ol-l
MV Lower Limit
orl
MV Change Rate Limit
db
Position Proportional
Dead Band
oc-h
Open/Close Hysteresis
sqrp
Extraction of Square
Root Low-cut Point
Work Bit * ON Delay w1 to
Work Bit * OFF Delay w1 to
plcm
Communications
Monitor
*1 This setting is not displayed for heating and cooling control or for floating position-proportional control.
E5@C-T Digital Temperature Controllers User's Manual (H185)
Setting (monitor) value
Temperature input: 0.1 to 999.9
Analog input: 0.01 to 99.99
Temperature input: 0.1 to 999.9
Analog input: 0.01 to 99.99
Standard: −5.0 to 105.0
Heating/cooling: −105.0 to 105.0
Floating position-proportional control or the Direct
Setting of Position-proportional MV parameter set to
OFF: CLOS, HOLD, or OPEN
Close position-proportional control with the Direct
Setting of Position-proportional MV parameter set to
ON: −5.0 to 105.0
Same as for MV at Reset.
Standard control: MV lower limit + 0.1 to 105.0
Heating/cooling control: 0.0 to 105.0
Close position-proportional control: MV lower limit +
0.1 to 105.0
Standard control: −5.0 to MV upper limit − 0.1
Heating/cooling control: −105.0 to 0.0
Close position-proportional control: −5.0 to MV
upper limit −0.1
0.0 to 100.0
(0.0: MV Change Rate Limit Disabled)
Close position-proportional control: 0.1 to 10.0
Floating position-proportional control: 0.1 to 10.0
0.1 to 20.0
0.0 to 100.0
8on 0 to 9999
8of 0 to 9999
0 to 9999
A Appendices
Display Default
°C or °F
1.0
0.10 %FS
°C or °F
1.0
0.10 %FS
0.0 %
clos hold
HOLD None
, ,
open
0.0 %
100.0 %
0.0 %
−100.0
0.0
0.0 %/s
4.0 %
2.0
0.8 %
0.0 %
0 Seconds
0 Seconds
ms
Unit
A
A - 21