Omron E5AC-T User Manual page 300

mv-r
• This parameter sets the MV when switching between run status and reset status during
Run/Reset control. However, if the reset operation is set to a fixed SP operation, the MV
at reset is not used.
Function
• The parameter is masked by default and not displayed.
Standard
Setting
Position proportional (Closed and direct setting of
position proportional MV is ON.)
Heating/cooling
Position Proportional
(Floating or direct setting of position proportional MV is
OFF.)
Related Parameters
See
See
Run/Reset (Operation Level): Page 6-14
Parameter Mask Setting (Advanced Function Setting Level): Page 6-110
mV-e
• This parameter sets the MV to use when an input error occurs.
• This parameter is masked by default and not displayed.
Function
Setting
Standard
Position proportional (Closed and direct setting of
position proportional MV is ON.)
Heating/cooling
Position Proportional
(Floating or direct setting of position proportional MV is
OFF.)
Related Parameters
See
See
Close/Floating (Initial Setting Level): Page 6-75
Direct Setting of Position Proportional MV (Advanced Function Setting Level): Page
6-102
Parameter Mask Setting (Advanced Function Setting Level): Page 6-110
E5@C-T Digital Temperature Controllers User's Manual (H185)
MV at Reset
Control method
MV at PV Error
Control method
The control must be set to 2-PID control and the
Reset Operation parameter must be set to stop
control.
Setting range
−5.0 to 105.0
−105.0 to 105.0
CLOS, HOLD, or
OPEN
The control must be set to 2-PID control or a
Position-proportional Model must be used.
Setting range
−5.0 to 105.0
−105.0 to 105.0
CLOS, HOLD, or
OPEN
6 Parameters
Unit Default
% 0.0
None HOLD
6
Unit Default
% 0.0
None HOLD
6 - 39