Omron E5AC-T User Manual page 255

5 Advanced Operations
Parameter Tab Pages
This section describes the parameters that are displayed on each tab page.
Basic Tab Page
Use this tab page to set the parameters that are used by all programs.
Parameter name
Program Time Unit
Step Time/Ramp Rate
Programming (Rate of
Rise Programming)
Time Unit of Ramp
Rate
Program End ON Time
Program SP Shift
Value
Standby Time Unit
Standby Time
Program Number
PV Start
Operation End
Operation
5 - 94
Description
This parameter sets the time unit for the
program.
This parameter specifies the segment
setting method when a program is set.
This parameter sets the time unit for the
denominator of the Segment Slope
parameter.
This parameter sets the pulse width of the
program end output.
This parameter performs a fixed-rate
compensation (1-point compensation) for
the program SP (PSP).
This parameter sets the unit for the
standby time.
This parameter is used to set the time
from when the run command is executed
until the program starts operation.
This parameter specifies the program
number to use to start program operation.
This parameter is used to set the method
for starting the program.
This parameter is used to specify the
operation status after the program has
been completed.
o
Controller Setting Level
Initial Setting Level
Initial Setting Level
Initial Setting Level
Advanced Function
Setting Level
Adjustment Level
Advanced Function
Setting Level
Adjustment Level
Operation Level
Initial Setting Level
Initial Setting Level
E5@C-T Digital Temperature Controllers User's Manual (H185)
Page
6-58
6-59
6-59
6-82
6-35
6-82
6-34
6-10
6-62
6-61