Omron E5AC-T User Manual page 269

6 Parameters
The following table shows the contents of the No. 1, 2, and 3 displays, according to the set-
ting of the PV/SP Display Screen Selection parameter.
Function
Set value
Setting
Process value
* The SP can be set in Fixed SP Mode (FSP). In Program SP Mode (PSP), the SP is displayed for
reference only.
During temperature input, the decimal point position depends on the currently selected sen-
sor, and during analog input it depends on the Decimal Point parameter setting.
PV/SP Display Selections
PV/SP No. 1 Display Selection
PV/SP No. 2 Display Selection
Related Parameters
See
See
PV/SP Display Selection (Advanced Function Setting Level): Page 6-107
6 - 8
Process Value/Set Point 1
Process Value/Set Point 2
No. 1 display
0 Nothing is displayed.
1 Process value
2 Process value
3 Set point
4 Process value
5 Process value
6 Process value
7 Process value
Temperature input: The specified range for the specified sensor.
Analog input: Scaling lower limit −5% FS to Scaling upper limit +5%
FS
Set point SP lower limit to SP upper limit*
Parameter
PV/SP No. 1 Display Selection must not be set to 0.
PV/SP No. 2 Display Selection must not be set to 0.
No. 2 display
Nothing is displayed. Nothing is displayed.
Set point Nothing is displayed.
Nothing is displayed. Nothing is displayed.
SP (character display) Nothing is displayed.
Set point MV monitor (heating) (valve
opening for Position-proportional
Models)
Set point MV monitor (cooling)
Set point Program No. monitor/Segment
No. monitor
Set point Remaining segment time
Monitor range
Setting range
Default
6
E5CC-T: 0
E5EC-T/E5AC-T: 7
E5@C-T Digital Temperature Controllers User's Manual (H185)
No. 3 display
(E5EC-T/E5AC-T only)
Unit
EU
Unit
EU