Omron E5AC-T User Manual page 336

Setting
*1 This function
Position-proportional Models, but the setting will be disabled.
*2 This function can be set only for a Controller that supports communications. Also, if a work bit is
selected as the event input data, you cannot select communications writing enable/disable.
clfl
• The Close/Floating parameter is used to set the control method for a
Position-proportional Model.
Function
flot: Floating control
Setting
clos: Close control
E5@C-T Digital Temperature Controllers User's Manual (H185)
Setting
none
None
rr-1
Run (OFF)/Reset (ON)
rr-2
Run (ON)/ Reset (OFF)
manu
Auto/Manual
rst
Reset
run
Run
hld1
Hold/Clear Hold
hld2
Hold
adv
Advance
prg0
Program Number Switch 0
prg1
Program Number Switch 1
prg2
Program Number Switch 2
drs
Direct/Reverse Operation
spm
Program SP Mode/Fixed SP Mode
at-2
100% AT Execute/Cancel
at-1
40% AT Execute/Cancel
ata2
All PID 100% AT Execute/Cancel
ata1
All PID 40% AT Execute/Cancel
wtpt
Setting Change Enable/Disable
cmwt
Communications Writing Enable/Disable
lat
Alarm Latch Cancel
wait
Wait Enable (ON)/Disable (OFF)
can be set for heating/cooling control or for
Close/Floating
Setting range
Function
*1
*1
*2
A Position-proportional Model must be used.
Default
flot
6 Parameters
6
floating control for
6 - 75