Removing The Lcd Module - Dell poweredge t330 Owner's Manual

CAUTION: Take care not to damage the mylar covering the ID switch.
2. Slide the control panel board toward the front of the control panel to lock the slide tabs and the
screw holes into the respective slots on the control panel.
3. Tighten the screws to secure the control panel board to the control panel.
Next steps
1. Install the control panel assembly cover.
2. Install the control panel assembly.
3. Follow the procedure listed in
Related Tasks
Installing the control panel assembly cover
Installing the control panel assembly

Removing the LCD module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in
4. Remove the control panel assembly.
5. Remove the control panel assembly cover.
Steps
1. Disconnect the LCD cable. Perform the following steps to disconnect the LCD cable:
a. Pull the retention tab that secures the LCD cable to the LCD cable connector on the control
panel board.
b. Pull the LCD cable out of the LCD cable connector.
2. Remove the screw that secures the LCD module to the control panel.
3. Remove the LCD module out of the control panel assembly.
After working inside your
Safety instructions.
Before working inside your
system.
system.
127