Selection Of The Measured Variable And Measuring Range - ProMinent DULCOMETER D1Cb Assembly And Operating Instructions Manual

Commissioning
5.1.2

Selection of the Measured Variable and Measuring Range

WARNING!
Incorrect metering due to incorrect measuring range
Possible consequence: Fatal or serious injuries.
– The measuring range of the sensor is essential for the measuring range!
– If the assignment of the measuring range is modified, the settings must be
checked in all menus
– If the assignment of the measuring range is changed, the sensor must be recali‐
brated
With devices, which have not been preconfigured to the customer's specific requirement,
the measured variable required has to be selected in the complete operating menu "Gen‐
eral Settings / Change Measured Variable". The DULCOMETER
to be labelled with the label corresponding to the measured variable selected. The rele‐
vant labels are enclosed with the DULCOMETER
general setting
Information
Fig. 24: Selection of measured variable and measuring range
The measuring range required has to be selected and set in the complete operating
menu General Settings / Change Measured Variable, see
Measured Variable/Measuring Range' on page 131 .
54
Identcode:
D1CBxxxxxxxxxxx
Vxxxxxxxxxxxx
Srnr: xxxxxxxxxx
®
® D1Cb / D1Cc.
wash timer
measure change
add. functions
Software version
Ä Chapter 10.6.1 'Setting the
D1Cb / D1Cc then has
chlorit
Br
O3
O2
effective range
0...2.00ppm
A0032