Telnet Command: Wan Lb - Draytek vigor2760 series User Manual

always_on
target
ip addr
ttl
status
E x a m p l e
E x a m p l e
> wan detect status
WAN1: always on
WAN2: off
WAN3: off
WAN4: off
WAN5: off
> wan detect wan1 target 192.168.1.78
Set OK
> wan detect wan1 on
Set OK
> wan detect status
WAN1: on, Target=192.168.1.78, TTL=255
WAN2: off
WAN3: off
WAN4: off
WAN5: off
>
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows you to Enable/Disable for each WAN to join auto load balance member.
wan lb [wan1/wan2] on
wan lb [wan1/wan2] off
S y n t a x D e
S y n t a x D e
Parameter
wan1/wan2
on
off
E x a m p l e
E x a m p l e
disable link detect, always connected(only support static IP)
It means to set the ping target.
It means the IP address used for detection. Type an IP
address in this field.
It means to set the ping TTL value (work as trace route)
If you do not set any value for ttl here or just type 0 here, the
system will use default setting (255) as the ttl value.
It means to show the current status.
: w a n l b
: w a n l b
s c r i p t i o n
s c r i p t i o n
Description
It means to specify which WAN will be applied with load
balance.
It means to make WAN1/WAN2 as the member of load
balance.
It means to cancel WAN1/WAN2 as the member of load
balance.
591 Vigor2760 Series User's Guide