Telnet Command: Ipf Set - Draytek vigor2760 series User Manual

T e l n e t C o m m
T e l n e t C o m m
This command is used to set general rule for firewall.
ipf set [Options]
ipf set [SET_NO] rule [RULE_NO] [Options]
S y n t a x
S y n t a x
Parameter
Options
SET_NO
RULE_NO
-v
-c [SET_NO]
-d [SET_NO]
-l [VALUE]
- p [VALUE]
-M [P2P_NO]
-U [URL_NO]
-a [AD_SET]
-f [VALUE]
-E [VALUE]
-F [VALUE]
-Q [VALUE]
E x a m p
E x a m p
Vigor2760 Series User's Guide
a n d : i p f s e t
a n d : i p f s e t
D e s c r i p t i o n
D e s c r i p t i o n
Description
There are several options provided here, such as -v, -c
[SET_NO], -d [SET_NO],... and etc.
It means to specify the index number (from 1 to 12) of filter
set.
It means to specify the index number (from 1 to 7) of filter
rule set.
Type "-v" to view the configuration of general set.
It means to setup Call Filter, e.g., -c 2. The range for the
index number you can type is "0" to "12" (0 means "disable).
It means to setup Data Filter, e.g., -d 3. The range for the
index number you can type is "0" to "12" (0 means "disable).
It means to setup Log Flag, e.g., -l 2
Type "0" to disable the log flag.
Type "1" to display the log of passed packet.
Type "2" to display the log of blocked packet.
Type "3" to display the log of non-matching packet.
It means to setup actions for packet not matching any rule,
e.g., -p 1
Type "0" to let all the packets pass;
Type "1" to block all the packets.
It means to configure IM/P2P for the packets not matching
with any rule, e.g., -M 1
Type "0" to let all the packets pass;
Type "1" to block all the packets.
It means to configure URL content filter for the packets not
matching with any rule, e.g., -U 1
Type "0" to let all the packets pass;
Type "1" to block all the packets.
It means to configure the advanced settings.
It means to accept large incoming fragmented UDP or ICMP
packets.
It means to set the maximum count for session limitation.
It means to configure the load-balance policy.
It means to set the QoS class.
l e
l e
504