Draytek vigor2760 series User Manual page 150

Current IPv6 Address
Table
DNS Server IPv6 Address
Management
DHCPv6 Server
Advance setting
Vigor2760 Series User's Guide
IPv6 address specified manually via ULA configuration. It
is convenient for communication among different subnets.
Auto ULA Prefix – The system will generate the required
IPv6 address.
Manually ULA Prefix – A user can type the ULA IPv6
address manually.
Display current used IPv6 addresses.
Primary DNS Sever – Type the IPv6 address for Primary
DNS server.
Secondary DNS Server –Type another IPv6 address for
DNS server if required.
Host under LAN can be assigned IP address from Vigor
router via the following method.

SLAAC(stateless) – The IP address (with Prefix) of
the host shall be formed according to RA transmitted by
Vigor router.

DHCPv6(stateful) - The IP address of the host shall be
assigned after communicating with DHCPv6 server for
answering the request of client.

Off – No IP address is assigned.
Other Option (O-bit) – Check this box to enable the O-bit
for obtaining additional information (e.g., DNS) from
DHCPv6.
Enable Server –Click it to enable DHCPv6 server.
DHCPv6 Server could assign IPv6 address to PC according
to the Start/End IPv6 address configuration.
Disable Server –Click it to disable DHCPv6 server.
Auto IPv6 range – After check the box, Vigor router will
assign the IPv6 range automatically.
Start IPv6 Address / End IPv6 Address –Type the start
and end address for IPv6 server.
More options are offered under the Advance setting. Click
Edit to open the pop-up window.
134