Draytek vigor2760 series User Manual page 359

Subnet
User Name
Password
Enable Mobile
One-Time Passwords
(mOTP)
IKE Authentication
Method
IPSec Security Method
PPTP/L2TP/IPSec)
If you check this box, the function of SSL Tunnel for this
account will be activated immediately.
Specify Remote Node - Check the checkbox to specify the
IP address of the remote dial-in user, ISDN number or peer
ID (used in IKE aggressive mode). If you uncheck the
checkbox, the connection type you select above will apply
the authentication methods and security methods in the
general settings.
Netbios Naming Packet

Pass – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel
while connecting.

Block – When there is conflict occurred between the
hosts on both sides of VPN Tunnel in connecting, such
function can block data transmission of Netbios Naming
Packet inside the tunnel.
Multicast via VPN - Some programs might send multicast
packets via VPN connection.
Pass – Click this button to let multicast packets pass through
the router.
Block – This is default setting. Click this button to let
multicast packets be blocked by the router.
Chose one of the subnet selections for such VPN profile.
Assign Static IP Address – Please type a static IP address
for the subnet you specified.
This field is applicable when you select PPTP or L2TP with
or without IPSec policy above.
This field is applicable when you select PPTP or L2TP with
or without IPSec policy above.
Check this box to make the authentication with mOTP
function.
PIN Code – Type the code for authentication (e.g, 1234).
Secret – Use the 32 digit-secret number generated by mOTP
in the mobile phone (e.g., e759bb6f0e94c7ab4fe6).
This group of fields is applicable for IPSec Tunnels and
L2TP with IPSec Policy when you specify the IP address of
the remote node. The only exception is Digital Signature
(X.509) can be set when you select IPSec tunnel either with
or without specify the IP address of the remote node.
Pre-Shared Key - Check the box of Pre-Shared Key to
invoke this function and type in the required characters
(1-63) as the pre-shared key.
Digital Signature (X.509) – Check the box of Digital
Signature to invoke this function and Select one predefined
Profiles set in the VPN and Remote Access >>IPSec Peer
Identity.
This group of fields is a must for IPSec Tunnels and L2TP
343 Vigor2760 Series User's Guide