Draytek vigor2760 series User Manual page 572

-r <remove>
-f <flush>
E x a m p
E x a m p
> srv nat openport 1 1 -a 1 -c games -i 192.168.1.100 -w 1 -p TCP -s
23 -e 83
> srv nat openport -v
%% Status: Enable
%% Comment: games
%% Private IP address: 192.168.1.100
Index
*****************************************************************
1.
%% Status: Disable
%% Comment:
%% Private IP address: 0.0.0.0
Index
*****************************************************************
%% Status: Disable
%% Comment:
%% Private IP address: 0.0.0.0
Index
*****************************************************************
>
Telnet Command: srv nat portmap
This command allows users to set port redirection table for NAT server.
srv nat portmap add [idx][serv name][proto][pub port][pri ip][pri port][wan1/wan2]
srv nat portmap del [idx]
srv nat portmap disable [idx]
srv nat portmap enable [idx] [proto]
srv nat portmap flush
srv nat portmap table
S y n t a x
S y n t a x
Parameter
Add[idx]
serv name
proto
Vigor2760 Series User's Guide
It means to delete the specified open port setting.
remove: Type the index number of the profile.
It means to return to factory settings for all the open ports
profiles.
l e
l e
Protocal
TCP 23
Protocal
Protocal
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means to add a new port redirection table with an index
number. Available index number is from 1 to 10.
It means to type one name as service name.
It means to specify TCP or UDP as the protocol.
Start Port End Port
83
Start Port End Port
Start Port End Port
556