Draytek vigor2760 series User Manual page 597
High speed vdsl2 router
Hide thumbs
Also See for vigor2760 series:
- User manual (430 pages) ,
- Quick start manual (39 pages) ,
- User manual (324 pages)
Table of Contents
Advertisement
peerid
iname
ipwd
ivj
ikey
imeth
For TCP/IP Settings
mywip
rgip
rnip
rnmask
rip
mode
droute
E
x
a
m
p
l
e
E
x
a
m
p
l
e
address of 203.12.23.48.
Type "off" means any remote IP is allowed to dial in.
It means the peer ID for Remote VPN Gateway.
Type "draytek" means the word is used as local ID.
It means Dial-in Username.
"iname=admin" means to set username as "admin".
It means Dial-in Password.
"ipwd=1234" means to set password as "1234".
It means VJ Compression.
"ivj=on/off" means to enable /disable VJ Compression.
It means IKE Pre-Shared Key.
"ikey=abcd" means to set IKE Pre-Shared Key = abcd.
It means IPSec Security Method
"imeth=h" means "Allow AH".
"imeth=d" means "Allow DES".
"imeth=3" means "Allow 3DES".
"imeth=a" means "Allow AES.
It means My WAN IP.
"mywip=1.2.3.4" means to set My WAN IP as "1.2.3.4".
It means Remote Gateway IP.
"rgip=1.2.3.4" means to set Remote Gateway IP as "1.2.3.4".
It means Remote Network IP.
"rnip=1.2.3.0" means to set Remote Network IP as "1.2.3.0".
It means Remote Network Mask.
"rnmask=255.255.255.0" means to set Remote Network
Mask as "255.255.255.0".
It means RIP Direction.
"rip=d" means to set RIP Direction as "Disable".
"rip=t" means to set RIP Direction as "TX".
"rip=r" means to set RIP Direction as "RX".
"rip=b" means to set RIP Direction as "Both".
It means the option of "From first subnet to remote network,
you have to do".
"mode=r" means to set Route mode.
"mode=n" means to set NAT mode.
It means to Change default route to this VPN tunnel ( Only
single WAN supports this).
droute=on/off means to enable/disable the function.
581
Vigor2760 Series User's Guide
Advertisement
Table of Contents
