Cisco catalyst 3750 Command Reference Manual page 76

auto qos voip
Table 2-2
Table 2-2
Ingress Queue
SRR
Priority
1. SRR = shaped round robin. Ingress queues support shared mode only.
Table 2-3
Table 2-3 Auto-QoS Configuration for the Egress Queues
Egress Queue Queue Number
Priority (shaped) 1
SRR shared 2
SRR shared 3
SRR shared 4
Command Modes Interface configuration
Command History Release
12.1(14)EA1
12.2(20)SE
12.2(40)SE
Usage Guidelines
Use this command to configure the QoS appropriate for VoIP traffic within the QoS domain. The QoS
domain includes the switch, the interior of the network, and edge devices that can classify incoming
traffic for QoS.
Auto-QoS configures the switch for VoIP with Cisco IP Phones on switch and routed ports and for VoIP
with devices running the Cisco SoftPhone application. These releases support only Cisco IP SoftPhone
Version 1.3(3) or later. Connected devices must use Cisco Call Manager Version 4 or later.
The show auto qos command output shows the service policy information for the Cisco IP phone.
To take advantage of the auto-QoS defaults, you should enable auto-QoS before you configure other QoS
commands. You can fine-tune the auto-QoS configuration after you enable auto-QoS.
Catalyst 3750 Switch Command Reference
2-46
shows the generated auto-QoS configuration for the ingress queues.
Auto-QoS Configuration for the Ingress Queues
Queue Number
1
shared 1
2
shows the generated auto-QoS configuration for the egress queues.
CoS-to-Queue Map
5
3, 6, 7
2, 4
0, 1
Modification
This command was introduced.
The cisco-softphone keyword was added, and the generated auto-QoS
configuration changed.
The information in the command output changed.
Chapter 2
Queue Weight
CoS-to-Queue Map (Bandwidth)
0, 1 81 percent
2, 3, 4, 5, 6, 7 19 percent
Queue (Buffer) Size
Queue Weight for Gigabit-Capable
(Bandwidth) Ports
up to100 percent 16 percent
10 percent 6 percent
60 percent 17 percent
20 percent 61 percent
Catalyst 3750 Switch Cisco IOS Commands
Queue (Buffer)
Size
67 percent
33 percent
Queue (Buffer)
Size for 10/100
Ethernet Ports
10 percent
10 percent
26 percent
54 percent
OL-8552-07