Cisco catalyst 3750 Command Reference Manual page 217

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
vmps
interval interval
Defaults
Recovery is disabled for all causes.
The default recovery interval is 300 seconds.
Command Modes Global configuration
Command History Release
12.1(11)AX
12.1(14)EA1
12.1(19)EA1
12.2(18)SE
12.2(20)SE
12.2(25)SE
12.2(37)SE
Usage Guidelines
A cause (link-flap, bpduguard, and so forth) is defined as the reason that the error-disabled state
occurred. When a cause is detected on a port, the port is placed in the error-disabled state, an operational
state similar to the link-down state.
When a port is error-disabled, it is effectively shut down, and no traffic is sent or received on the port. For
the BPDU guard and port-security features, you can configure the switch to shut down just the offending
VLAN on the port when a violation occurs, instead of shutting down the entire port.
If you do not enable the recovery for the cause, the port stays in the error-disabled state until you enter
the shutdown and the no shutdown interface configuration commands. If you enable the recovery for a
cause, the port is brought out of the error-disabled state and allowed to retry the operation again when
all the causes have timed out.
Otherwise, you must enter the shutdown and then the no shutdown commands to manually recover a
port from the error-disabled state.
OL-8552-07
Enable the timer to recover from the VLAN Membership Policy Server
(VMPS) error-disabled state.
Specify the time to recover from the specified error-disabled state. The range
is 30 to 86400 seconds. The same interval is applied to all causes. The default
interval is 300 seconds.
The error-disabled recovery timer is initialized at a random
Note
differential from the configured interval value. The difference
between the actual timeout value and the configured value can be up
to 15 percent of the configured interval.
Modification
This command was introduced.
The security-violation keyword was added. The gbic-invalid keyword is
supported for SFP module ports.
The dhcp-rate-limit keyword was added.
The channel-misconfig keyword was added.
The arp-inspection keyword was added.
The l2ptguard keyword was added.
The per-VLAN error-detection feature was added. The inline-power and
sfp-mismatch keywords were added.
Catalyst 3750 Switch Command Reference
errdisable recovery
2-187