Diagnostic Monitor - Cisco catalyst 3750 Command Reference Manual

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

diagnostic monitor

Use the diagnostic monitor global configuration command to configure the health-monitoring diagnostic
testing. Use the no form of this command to disable testing and return to the default settings.
Syntax Description switch num
test
test-id
test-id-range
all
interval
hh:mm:ss
milliseconds
day
syslog
threshold
failure count
count
Defaults
The defaults are as follows:
•
•
OL-8552-07
diagnostic monitor switch {num} test {test-id | test-id-range | all}
diagnostic monitor interval switch {num} test {test-id | test-id-range | all} hh:mm:ss milliseconds
day
diagnostic monitor syslog
diagnostic monitor threshold switch {num} test {test-id | test-id-range | all} count failure count
no diagnostic monitor switch {num} test {test-id | test-id-range | all}
no diagnostic monitor interval switch {num} test {test-id | test-id-range | all}
no diagnostic monitor syslog
no diagnostic monitor threshold switch {num} test {test-id | test-id-range | all} failure count
Specify the module number. The range is from 1 to 9.
Specify a test to run.
Identification number for the test to be run; see the "Usage Guidelines"
section for additional information.
Range of identification numbers for tests to be run; see the "Usage
Guidelines" section for additional information.
Run all the diagnostic tests.
Specify an interval between tests to be run.
Specify the number of time between tests; see the "Usage Guidelines"
section for formatting guidelines.
Specify the time in milliseconds; valid values are 0 to 999.
Specify the number of days between tests; see the "Usage Guidelines"
section for formatting guidelines.
Enable the generation of a syslog message when a health-monitoring test
fails.
Specify the failure threshold.
Specify the failure threshold count.
Monitoring is disabled.
syslog is enabled.
Catalyst 3750 Switch Command Reference
diagnostic monitor
2-121