Interface Range - Cisco catalyst 3750 Command Reference Manual

Hide thumbs Also See for catalyst 3750:
Table of Contents

Advertisement

interface range

interface range
Use the interface range global configuration command to enter interface range configuration mode and
to execute a command on multiple ports at the same time. Use the no form of this command to remove
an interface range.
Syntax Description
port-range
macro name
Defaults
This command has no default setting.
Command Modes
Global configuration
Command History
Release
12.1(11)AX
Usage Guidelines
When you enter interface range configuration mode, all interface parameters you enter are attributed to
all interfaces within the range.
For VLANs, you can use the interface range command only on existing VLAN switch virtual interfaces
(SVIs). To display VLAN SVIs, enter the show running-config privileged EXEC command. VLANs
not displayed cannot be used in the interface range command. The commands entered under interface
range command are applied to all existing VLAN SVIs in the range.
All configuration changes made to an interface range are saved to NVRAM, but the interface range itself
is not saved to NVRAM.
You can enter the interface range in two ways:
All interfaces in a range must be the same type; that is, all Fast Ethernet ports, all Gigabit Ethernet ports,
all EtherChannel ports, or all VLANs. However, you can define up to five interface ranges with a single
command, with each range separated by a comma.
Valid values for port-range type and interface:
Catalyst 3750 Switch Command Reference
2-196
interface range {port-range | macro name}
no interface range {port-range | macro name}
Port range. For a list of valid values for port-range, see the "Usage Guidelines"
section.
Specify the name of a macro.
Modification
This command was introduced.
Specifying up to five interface ranges
Specifying a previously defined interface-range macro
vlan vlan-ID - vlan-ID, where VLAN ID is from 1 to 4094
fastethernet stack member/module/{first port} - {last port}, where module is always 0
Chapter 2
Catalyst 3750 Switch Cisco IOS Commands
OL-8552-07

Advertisement

Table of Contents
loading

Table of Contents