Switchport Voice Detect - Cisco catalyst 3750 Command Reference Manual

Chapter 2 Catalyst 3750 Switch Cisco IOS Commands

switchport voice detect

Use the switchport voice detect interface configuration command to detect and recognize a Cisco IP
phone. Use the no form of this command to return to the default setting.
Syntax Description
cisco-phone
full-duplex
Command History Release
12.2(37)SE
Usage Guidelines Use this command to detect and recognize a Cisco IP phone.
Examples
This example shows how to enable switchport voice detect on the switch:
Switch(config)# interface fastethernet 1/0/1
Switch(config-if)# switchport voice detect cisco-phone
This example shows how to disable switchport voice detect on the switch:
Switch(config)# interface fastethernet 1/0/1
Switch(config-if)# no switchport voice detect cisco-phone
You can verify your settings by entering the show run interfaces interface-id privileged EXEC
command.
Related Commands
No related commands.
OL-8552-07
switchport voice detect cisco-phone [full-duplex]
no switchport voice detect cisco-phone [full-duplex]
Configure the switch to detect and recognize a Cisco IP phone.
(optional) Configure the switch to only accept a full-duplex Cisco IP phone.
Modification
This command was introduced.
switchport voice detect
Catalyst 3750 Switch Command Reference
2-863