Cisco catalyst 3750 Command Reference Manual page 146

deny (IPv6 access-list configuration)
Although visible in the command-line help strings, the flow-label, routing, and
Note
undetermined-transport keywords are not supported.
Defaults
No IPv6 access list is defined.
Command Modes
IPv6 access list configuration
Command History Release
12.2(25)SED
Usage Guidelines
The deny (IPv6 access-list configuration mode) command is similar to the deny (IPv4 access-list
configuration mode) command, except that it is IPv6-specific.
Use the deny (IPv6) command after the
mode and to define the conditions under which a packet passes the access list.
Specifying IPv6 for the protocol argument matches against the IPv6 header of the packet.
By default, the first statement in an access list is number 10, and the subsequent statements are numbered
in increments of 10.
You can add permit, deny, or remark statements to an existing access list without re-entering the entire
list. To add a new statement anywhere other than at the end of the list, create a new statement with an
appropriate entry number that falls between two existing entry numbers to show where it belongs.
Every IPv6 ACL has implicit permit icmp any any nd-na, permit icmp any any nd-ns, and deny ipv6
Note
any any statements as its last match conditions. The two permit conditions allow ICMPv6 neighbor
discovery. To disallow ICMPv6 neighbor discovery and to deny icmp any any nd-na or icmp any any
nd-ns, there must be an explicit deny entry in the ACL. For the implicit deny ipv6 any any statement
to take effect, an IPv6 ACL must contain at least one entry.
The IPv6 neighbor discovery process uses the IPv6 network layer service. Therefore, by default, IPv6
ACLs implicitly allow IPv6 neighbor discovery packets to be sent and received on an interface. In IPv4,
the Address Resolution Protocol (ARP), which is equivalent to the IPv6 neighbor discovery process,
uses a separate data-link layer protocol. Therefore, by default, IPv4 ACLs implicitly allow ARP packets
to be sent and received on an interface.
Both the source-ipv6-prefix/prefix-length and destination-ipv6-prefix/prefix-length arguments are used
for traffic filtering. (The source prefix filters traffic based upon the traffic source; the destination prefix
filters traffic based upon the traffic destination.)
The switch supports only prefixes from /0 to /64 and EUI-based /128 prefixes for aggregatable global
unicast and link-local host addresses.
The fragments keyword is an option only if the protocol is ipv6 and the operator [port-number]
arguments are not specified.
Catalyst 3750 Switch Command Reference
2-116
Modification
This command was introduced.
ipv6 access-list
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
command to enter IPv6 access list configuration
OL-8552-07