A02 Def. Display; Meter Display; A03 Run Display - Zener MSC-3 Instruction Manual

A02 Def. Display

Available Choices:
• Press  once to begin.
• Use the ▲ / ▼ buttons to choose a default display.
• Press  to confirm the choice.
The selected display will show when the MSC3 is powered on or when a menu is on show and left
unattended for 2 minutes.

Meter Display

The Meter Display shows other
MSC-3 operating values such as
output current, output power, motor
load as well as motor speed. The PID
facet displays the process variable
and set point value. The PID-Meter
facet helps to relate the motor speed,
output power and motor current to the
Process variable. The kWhrs & Hours
Run facet displays the accumulated
kWhrs to the motor and the numbers
of hours the motor has been running
for. Each Meter Display facet is viewed
by pressing the  button.
Note: Each example display is shown
with the EIA/RS-485 communication
indicator.

A03 Run Display

This menu allows for Run Display configuration. Menus within provide a mechanism to select the run
display format, alter the run display scaling and change the displayed units.
A02 Def. Display
> METER DISPLAY
> SPEED-REF DISP
> METER DISPLAY
> PID DISPLAY
> PID-METER DISP
> kWhrs & Run hrs
ENTER
A03 Run Display
IM00120 IM00120
MSC-3 Instruction Manual
(Meter Display facet)
25.0Hz 0.1kW
8.0A 0%*
(PID facet)
11.4 kPa
P
V
23.4 *
S
V
(PID-Meter facet)
25.0Hz 11.4kW
8.0A 750rpm*
(kWhrs & Hours Run facet)
0 kWhrs
0 hours*
ENTER
ENTER
ENTER
67